RESTORE 10X Advanced Resurfacer – Tips & Application Instructions
Page 4 of 5
8. TWO COATS
TWO COATS OF RESTORE 10X ADVANCED RESURFACER ARE REQUIRED. The first coat will go on to fill in cracks
and do other minor repairs. The product will soak into the wood and dry. The first coat may be blotchy and spotty.
The second coat works as a finishing coat and will give greater wear as the product ages. Be careful not to over
spread. Restore is made to be applied with an approximate coverage of up to 40 square feet with 2 coats per
gallon.
9. SMOOTHER FINISH
To achieve a smoother finish, a brush may be used to skim the surface of the 2nd coat. Apply the 1st coat as
directed with the Restore Honeycomb Roller and let it dry for 4-6 hours. Apply the second coat with the Restore
Honeycomb Roller to a section of the surface. While the product is still wet, use a synthetic bristle brush and lightly
skim the product in the opposite direction as rolled. Use care not to remove any of the material already in place by
applying too much pressure. Maintain a wet edge at all times and do not over work the product.
10. DIFFICULT AREAS
Such as warped or cupped deck boards will require rolling across the narrow width of deck board as well as the
length to ensure complete coverage. Restore 10X Advanced Resurfacer will fill nail holes and cracks up to ¼”.
Larger cracks can be filled using Restore Crack Filler.
11. DRYING TIMES
Dry times may vary due to weather conditions such as humidity, rain, high/low temperatures and seasonal
changes. Apply Restore 10X Advanced Resurfacer when no rain is expected for a minimum of 48 hours after
application. The second coat can be applied as early as 4 to 6 hours after the first coat, but if the area is still wet do
not apply until surface is not tacky to the touch. Allow the area to dry for a minimum 24 hours before walking on
the surface and 48 hours before placing furniture on the area.
Dry times are based off the optimal application temperature of 70 degrees. Allow more time to dry at lower
temperatures. Restore 10X Advanced Resurfacer should not be applied if temperatures are below 50 degrees and
above 90 degrees for 48 hours either day or night after application.
12. CLEAN UP
Restore 10X Advanced Resurfacer is a water based product that will clean up with soap and water. For best results
clean up should be done before the product dries. Cover the areas around spindles and walls to avoid splattering
during the application process.
13. COATING MAINTENANCE
Basic maintenance consists of sweeping or blowing clean the surface from dirt, leaves, and other debris. Clean the
surface seasonally and when necessary with Restore Deck & Concrete Cleaner, a brush and a water hose. DO NOT
USE A PRESSURE WASHER.
For snow removal use a PLASTIC SHOVEL (DO NOT USE A METAL SHOVEL OR A SNOW BLOWER)
DO NOT USE SALT ON THE SURFACE OF THE COATING
14. REMOVING RESTORE
Restore products are made to last and adhere for long periods of time. To remove Restore 10X Advanced
Resurfacer completely you can use Restore Deck Stripper or a stripper with sodium hydroxide.
WARNING: THIS PRODUCT CONTAINS CRYSTALLINE SILICA
DELAYED EFFECTS FROM LONG-TERM OVEREXPOSURE. Abrading or sanding of the dry film may release crystalline
silica, which has been shown to cause lung damage and cancer under long-term exposure.
(5 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals